Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 24.06.2025 02:13

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

What is lightning?

I post the exact comment here.

Barnstars:

Measles case confirmed in Allegan County, officials provide locations of exposure - WWMT

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

what exactly is a ‘surge’ protector?

Special Wagers for Belmont Stakes Racing Festival - BloodHorse

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

For this case there are devices called Metal oxide varistors (MOV).

[image of Common-mode choke]

If there was only one man remaining on the Earth, would this be regarded as extinction?

He then describes the function of a fuse.

The bolt then partially travels down the line to your home.

Now when you have a certain ac resistance, then a current flows in a loop.

I'm British and feel ashamed of the crimes of British colonialism. What should I do?

This is where the MOV conducts again, and dissipated the energy.

so, what happens?

2024–10–16 [ OO OLAOYE OYEBODE ]

I accidentally bought a protein powder that gains weight by mistake, can I still use it to lose weight if I only consume small portions? Or is it completely useless now?

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

This device then solves the entire problem.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

Can I use ChatGPT to get chapter ideas? I’ll be writing it with my own words but I just get writer’s block when it comes to what to write?

But it can get overloaded, and no longer works.

eight

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

Space humbles the SEAL-doctor-astronaut | On the ISS this week June 9-13, 2025 - Space

He then describes Rainy Season and Lightning.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

In schematic diagrams this is the symbol for a fuse:

Can people who have never met you tell if you are a covert narcissist?

[old diagram got deleted by accident]

the problem then depends on "how fast does the fuse operate?".

nine

Have you ever been spanked in front of a group of people?

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

These Diabetes Drugs Are Finding New Life as an Antiaging Hack - WSJ

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

a photo is worth a thousand words.

One

What do people aim for when they meditate, and how do they do it properly?

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

Antarctic detector picks up signals that defy all known laws of particle physics - Interesting Engineering

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

These are simplified answers to the original question, and does not change anything I wrote above.

So, the voltage could go up to 500 volts, and the fuse will not open up.

Ravens in "introductory stage" of Lamar Jackson extension talks - NBC Sports

What does a fuse do?

Because the load is inductive, the current lags the voltage.(by a bit).

Edit 2024–10.

How can I use AI to create custom music to accompany my vocal song or poetry?

2024–10–10[John johnson John Johnson ]

(Dc diagram shown, AC is similar).

The other is “what does a “fuse” do?”

Earth is Eating Itself: Vast Chunks Of Crust Are Being Swallowed From Within - The Daily Galaxy

2024–10–14 [Omar Gharbi Omar Gharbi ]

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

A fuse is a non-resetable over current circuit protector.

First Sentence:

Upvotes:

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

An AC voltage/ current source, and an ac inductive load.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

Here is a simplified AC power diagram.

One is “what exactly is in a ‘surge protector’ ? ”

But… the neutral is now “floating” because of the 1 ohm resistance.

A circuit breaker is similar, but is resettable.

The third is lightning and “how it gets conducted into a home.”

Can the fuse protect the electronic devices from lightning instead of a surge protector.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

This is 'the assistant's answer'

but this device (an Inductor) … impedes the rapid changes in the current.

This one hit behind the barn.

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

but I think this circuit , shows a few more pieces.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

This is where this question deviates from being a 'generic' question, and becomes more specific.

It seems Mohan does not understand the difference between a comment and an Answer.

There are three different concepts here that are getting confused.

The MOV will conduct when the voltage exceeds 50% of line voltage.

This is the picture of an electronic coil of wire wound around a core of magnetic material.

There are two important concepts here.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

At one ohm, the resistor has a maximum of 1 watt power.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

He then asserts :

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

At least they know the answer if they wanted it.

These devices are installed between the “hot” and “neutral” and protective ground.

It also is a device that limits the change in current flow.